Gate folding uses the two 4" panels and two 3-15/16" panels as well, but in different positions to accommodate the different folding arrangement. Overall page size is up to 15-13/16" x 9"ĭouble-folding uses two 4" panels and two 3-15/16" panels. Roll-folding requires that the fourth panel is reduced by another 1/16", down to 3-7/8".
Overall page size in Scribus 12" x 9" -Accordion-fold brochures can have as many panels as you like, the panels all stay the same size.Ĥ-panel brochures give even more options for folding and overall layout. The third panel is reduced by 1/16" so that the 3rd panel can be folded inside the first 2 without hitting the first fold on the inside, bowing out the panels.Ī 3-panel accordion-fold does not need to have a panel width reduction as the panels never fold inside of each other. Once you move past 2 panels, your page sizes may need to adjust to allow the piece to lay flat.Ī 3-panel roll-fold brochure adds a 3-15/16" wide panel to the end of the two previous 4" panels, resulting in an overall page size of 11-15/16" x 9". Layouts like this can add additional visual impact due to the dimensions of the piece.
This can be used as a very strong vertical, or rotated over to be used as a very strong horizontal. One could open vertically from the top or bottom resulting in a 4" x 18" page. That is assuming you want to open it like a book while holding it vertically. Your page size now becomes 8" x 9", folding to 4" x 9". Moving to a 2-panel layout is generally quite simple. Adding panels to a rack card to make a brochure provides many choices in the layout, without even placing a single graphic. The content usually printed on these is intended to display room rates and other pricing information, and will probably be found closer to the check-in or check-out counters, in their own holders, away from the rack. These are generally printed on a moderate cover weight stock, usually 65 pound to 80 pound cover either coated or uncoated (more information on paper wieghts can be found here). It is a simple 4" x 9" piece of paper with information printed on both sides (usually). The most basic Brochure is the Rack Card. All dimensions are given in inches and fractions of an inch. More complex layouts will have "front cover", "back cover", and "inside front cover", "inside back cover".
crop and fold marks will be provided in the bleed area (outside the trim guides). Guides will be placed for trim edges and folds. Supplied Scribus layouts will only have 2 pages (front and back or inside and outside). I refer to page sizes here as your overall page size in Scribus. Panels refer to the actual pages of the final brochure.
#BROCHURE DESIGNING IN SCRIBUS 1.4.8 HOW TO#
At the end I will give some design advice, but this is not a tutorial on typography, design layout, or how to make a stunning brochure that everyone will notice. The focus here is going to be in describing how to set up your Scribus document so that you can produce a brochure that prints and folds correctly. If you have ever stayed in a hotel, somewhere near the front desk is a large rack containing many cards and brochures, advertising local attractions, events, dining and even other places to stay. There are as many ways to make a brochure as there are designers, and then some!įor this article, I will focus on a common commercial sized brochure set that is found throughout the U.S. I should start by saying a "brochure" can be any of several, very different sized pieces.
0 kommentar(er)
